Hey guys Sig here, and today I have been tweaking my #Cura settings for my 3D Printer.
What I am trying to do is reduce the amount of blobbing that each layer creates. After doing a few test prints, I noticed that this was do to the retraction speed before starting the next layer. The retraction speed was at 2.5mm which caused many blobs and waste between layers. After changing the retraction speed to 4.0mm at a 1.5mm difference, the print quality increased massively. I have also increased my travel speed so that the time between starting the next layer has also been reduced which will further increase the quality of my prints. Once I feel that my settings are top notch and where I want them to be, I will start creating video content for you all to see on #Youtube. So back to the grind stone I go. Stay savvy guys!
댓글